Moving Violations Video No. 56, by Russ LeBlanc, NEC Consultant: Violation of Box Size

Discuss this Video 2

Anonymous (not verified)
on Sep 19, 2013

It is my understanding of 314.28 . for a straight pull it is 8 time the largest conduit plus all other conduits. thus this box should be 8 X 1" plus the second 1" or 9 x9 ( actually 10X 10 since a 9 X 9 is not available).

Anonymous (not verified)
on Sep 19, 2013

On long pulls like this I use a "c" condulet. Another advantage is the C does not have to be supported, if the conduit is supported properly. Dropping all thread to support a pull box and the cost of the pull box can be eliminated.

Please or Register to post comments.

Electrical Testing Feed

EC&M Webinars
Sep 10, 2015

ON DEMAND: An Effective Electrical Safety Program that Delivers

This hour-long webinar will cover the wording in various IEEE recommended practices, NFPA 70E and ANSI Z10 with an emphasis on what it means in terms of designing, implementing and managing an Effective Electrical Safety Program....More
Jul 21, 2015

ON DEMAND: Mitigation Methods for Arc Flash Hazards - Enhancing Personal Safety

The energy released during an arc flash event can result in severe damage to personnel, equipment, and property. While there are solutions which seek to improve the protection for each, this program will focus on personnel....More
EC&M Learning Center

Connect With Us

Sponsored Introduction Continue on to (or wait seconds) ×