Moving Violations Video No. 56, by Russ LeBlanc, NEC Consultant: Violation of Box Size

Discuss this Video 2

Anonymous (not verified)
on Sep 19, 2013

It is my understanding of 314.28 . for a straight pull it is 8 time the largest conduit plus all other conduits. thus this box should be 8 X 1" plus the second 1" or 9 x9 ( actually 10X 10 since a 9 X 9 is not available).

Anonymous (not verified)
on Sep 19, 2013

On long pulls like this I use a "c" condulet. Another advantage is the C does not have to be supported, if the conduit is supported properly. Dropping all thread to support a pull box and the cost of the pull box can be eliminated.

Please or Register to post comments.

Electrical Testing Feed

EC&M Webinars
Jul 21, 2015

ON DEMAND: Mitigation Methods for Arc Flash Hazards - Enhancing Personal Safety

The energy released during an arc flash event can result in severe damage to personnel, equipment, and property. While there are solutions which seek to improve the protection for each, this program will focus on personnel....More
Jul 14, 2015

ON DEMAND: Understanding the 2015 Edition of NFPA 70E and the Arc Flash Hazard

Get more information on the important changes to the 2015 edition of NFPA 70E. More specifically, this event will address hazard analysis and FR clothing performance testing, focusing on the quantification of incident energy and ATPV (or Arc Rating)....More
EC&M Learning Center

Connect With Us

Sponsored Introduction Continue on to (or wait seconds) ×