Moving Violations Video No. 55, by Russ LeBlanc, NEC Consultant: Violation of Working Space Requirements

Discuss this Video 1

Bernie (not verified)
on Sep 6, 2013

I agree with Russ that he illustrates an illegal condition, but am not sure from the video if the beam was there when the panel was installed. The beam looked fairly new and unrusted, it could have been added after to support the floor above. I sometimes take issue with the electrician being blamed for a poor installation, when the plumber or pipe-fitter adds an obstruction to the safe working area around a panel, after it was inspected.

Please or Register to post comments.

Electrical Testing Feed

EC&M Webinars
Sep 10, 2015

ON DEMAND: An Effective Electrical Safety Program that Delivers

This hour-long webinar will cover the wording in various IEEE recommended practices, NFPA 70E and ANSI Z10 with an emphasis on what it means in terms of designing, implementing and managing an Effective Electrical Safety Program....More
Jul 21, 2015

ON DEMAND: Mitigation Methods for Arc Flash Hazards - Enhancing Personal Safety

The energy released during an arc flash event can result in severe damage to personnel, equipment, and property. While there are solutions which seek to improve the protection for each, this program will focus on personnel....More
EC&M Learning Center

Connect With Us

Sponsored Introduction Continue on to (or wait seconds) ×