Moving Violations Video No. 35, by Russ LeBlanc, NEC Consultant: Non-Sunlight Resistant PVC Clips & Fittings

Discuss this Video 2

John Saporito (not verified)
on Nov 1, 2012

The electrical inspector must had taken a bribe.

anonymous (not verified)
on Nov 24, 2012

Bad enough that #12's are spliced to old cloth covered #10's. However, rather than cover the T-11 replace it with a 4x11/16 box & blank cover, remove the 30a CB or replace the conductors as needed. This video is indicative of the workmanship all too common today.

Please or Register to post comments.

Electrical Testing Feed

EC&M Webinars
Jul 21, 2015
Sponsored

ON DEMAND: Mitigation Methods for Arc Flash Hazards - Enhancing Personal Safety

The energy released during an arc flash event can result in severe damage to personnel, equipment, and property. While there are solutions which seek to improve the protection for each, this program will focus on personnel....More
Sep 10, 2015
Sponsored

An Effective Electrical Safety Program that Delivers

This hour-long webinar will cover the wording in various IEEE recommended practices, NFPA 70E and ANSI Z10 with an emphasis on what it means in terms of designing, implementing and managing an Effective Electrical Safety Program....More
EC&M Learning Center

Connect With Us

Sponsored Introduction Continue on to (or wait seconds) ×