Moving Violations Video No. 24, by Joe Tedesco, NEC Consultant, EC&M Magazine

Discuss this Video 1

on Jun 25, 2012

This was identified as a panelboard in the video. This panel looks more like a residential "load center". There is a difference. Although I agree, Factory panel info on the door should not be covered, it is usally useless, as the printing is usually so small you cannot read it. It is also not always put on properly. Sometimes these labels are sideways. Why did the manufacture not allow provisions for index ?

Please or Register to post comments.

Electrical Testing Feed

EC&M Webinars
Sep 10, 2015
Sponsored

An Effective Electrical Safety Program that Delivers

This hour-long webinar will cover the wording in various IEEE recommended practices, NFPA 70E and ANSI Z10 with an emphasis on what it means in terms of designing, implementing and managing an Effective Electrical Safety Program....More
Jul 21, 2015
Sponsored

ON DEMAND: Mitigation Methods for Arc Flash Hazards - Enhancing Personal Safety

The energy released during an arc flash event can result in severe damage to personnel, equipment, and property. While there are solutions which seek to improve the protection for each, this program will focus on personnel....More
EC&M Learning Center

Connect With Us

Sponsored Introduction Continue on to (or wait seconds) ×