What's Wrong Here?
Aug 20, 2009 10:20 AM, By Joe Tedesco, NEC Columnist
Hint: Is that an approved bonding jumper?
The Code allows you to install an equipment-bonding jumper inside or outside of a raceway or enclosure [250.102(E)]. If installed on the outside of the raceway, its length cannot exceed 6 ft, and you must route it with the raceway or enclosure. Although the length of this jumper does not exceed 6 ft, this piece of strapping iron (normally used for mechanical-type purposes) is no substitute for a properly sized conductor.
Sponsored by:
Back to Question | See Full List of Quizzes
Want to use this article? Click here for options!
© 2012 Penton Media, Inc.
Code Challenge
Code Quiz
May 10, 2012 12:29 PM, By Steven Owen, National Code Seminars
When installing a shielded cable or a twisted pair cable in a Class I, Division 1 location where a cable seal is required, when is it not required to remove the shielding material or separate the twisted pairs of those type cables?...
More Code Quizzes
Code Q&A
May 24, 2012 10:42 AM, By Mike Holt, NEC Consultant
Q. What labeling does the Code require in regard to arc flash hazard warning?...
More Code Q&As
Acceptable Use Policy blog comments powered by Disqus
What's Wrong Here
Sponsored By:
advertisement
what's wrong here?
What's Wrong Here?
May 10, 2012 12:44 PM
View all What's Wrong Here?
What's Wrong Here
Sponsored By:
product spotlight
EV charger tester
May 25, 2012 8:26 AM
The Electrician is portable tester that verifies critical power and safety requirements of electric vehicle (EV) chargers...
View all 2012 Product Spotlights
Free Product Info
Our Product Information site is the ultimate online resource for products and services offered by Advertisers featured in our Magazine. This service is provided as a quick and easy way to request Product Information online. Get FREE product information now.
Case Studies
Social Media
More ways to stay informed...
