Mike Holt

Mike
Holt
NEC Trainer / Consultant,
Mike Holt Enterprises
635

Mike earned a masters degree in the Business Administration Program (MBA) from the University of Miami. He earned his reputation as a National Electrical Code (NEC) expert by working his way up through the electrical trade. Formally a construction editor for two different trade publications, Mike started his career as an apprentice electrician and eventually became a master electrician, an electrical inspector, a contractor, and an educator. Since 1975, he has provided custom in-house seminars for groups such as IAEI, NECA, ICBO, IBM, AT&T, Motorola, and the U.S. Navy. Mike has taught more than 1,000 classes on 30 different electrical-related subjects — ranging from alarm installations to exam preparation and voltage drop calculations. He continues to develop seminars, videos, books, and software as well as contributing monthly Code content to EC&M magazine.

Articles
Code Q&A
Q. Does the NEC require a connection of a parking lot lighting pole to a ground rod?
Code Quandaries
Q. What size THHN conductor is required for a 320A 3-phase feeder load for commercial office buildings?
Article 424: Fixed Electric Space Heating
Considering the fact that it has nine parts, at first glance, Art. 424 might seem like overkill for a device as simple as a heater. Walk into any hardware
Code Q&A
Q. Is GFCI protection required for drinking water fountains in office buildings?
Code Q&A
Q. A 400A service is made up of two 200A main breaker panelboards that are nippled together. Can the service conductors pass through one of the cabinets to supply the other panelboard?
Grounding and Bonding of Separately Derived Systems
Separately derived systems (SDSs) include most transformers as well as any generator or UPS supplying a transfer switch that opens the neutral conductor.
Code Q&A
Q. What are the NEC requirements for the installation of smoke detectors in dwelling units?
Code Q&A 1
Q. What are the Code requirements for bonding bushings on 277V or 480V branch and feeder and circuits?
Stumped by the Code?
Q. What are the rules on spacing receptacles in a dwelling unit?
Transformer Secondary Conductors 3
Similar to feeder taps, covered in the last issue, transformer secondary conductors can be every bit as confusing. Let's take a closer look at 240.21(C)
Code Q&A
Q. When PVC conduit is used, does the Code require an equipment grounding conductor between the meter enclosure and the service disconnect?
Code Q&A
Q. Section 110.14(C) requires the use of the 60°C column for 100A or less and the 75°C column for above 100A for conductor sizing. What is the value of THHN rated 90°C if the ampacity cannot be used for conductor sizing?
Feeder Taps 2
Sometimes, it makes sense to tap into a feeder conductor to power another conductor. From Art. 100, we know that a feeder conductor runs between service
Code Q&A
Q. Is there any allowance in the NEC to locate receptacles in dwelling units where it is convenient for furniture layout or the designer’s wishes, if the required number of receptacles is installed?
Code Q&A
Q. Is it permissible to run heating/air-conditioning duct 4 feet above a panelboard if the ductwork services the room where the panelboard is located?

EC&M Learning Center

 

Newsletter Signup

Connect With Us

Sponsored Introduction Continue on to (or wait seconds) ×