Mike Holt

NEC Trainer / Consultant,
Mike Holt Enterprises

Mike earned a masters degree in the Business Administration Program (MBA) from the University of Miami. He earned his reputation as a National Electrical Code (NEC) expert by working his way up through the electrical trade. Formally a construction editor for two different trade publications, Mike started his career as an apprentice electrician and eventually became a master electrician, an electrical inspector, a contractor, and an educator. Since 1975, he has provided custom in-house seminars for groups such as IAEI, NECA, ICBO, IBM, AT&T, Motorola, and the U.S. Navy. Mike has taught more than 1,000 classes on 30 different electrical-related subjects — ranging from alarm installations to exam preparation and voltage drop calculations. He continues to develop seminars, videos, books, and software as well as contributing monthly Code content to EC&M magazine.

Approved Conductor Sizes for ITC Type Cable
Article 727 covers the use, installation and construction specifications of instrument tray cable for application to instrumentation and control circuits operating at 150V or less and 5A or less.
Conductor Installation Ratings for Strip Lights in Theaters and Studios
Article 520 covers all buildings or structures that used for presentation, dramatic, musical, motion picture projection or similar purposes along with the seating areas in motion picture or television studios.
Disconnect Requirements for Permanently Connected Appliances
Article 422 covers appliances used in any occupancy.
Service-Entrance Cable Requirements
Service-entrance conductor requirements are outlined in Part IV of Art. 230.
Rating Requirement for Equipment Fastened in Place
Branch circuit rating requirements are outlined in Part II of Art. 210.
The Four Pillars of NEC Chapter 3  7
Four NEC Articles form the basis for correctly applying Chapter 3 wiring methods.
AC Systems Not Required to be Grounded
Section 250.21 focuses on alternating-current systems of 50V to less than 1,000V that are not required to be grounded.
Insulation Rating of Conductor Used in Lighting Equipment
Conductor construction and application rules are outlined in Table 310.104(A) through Table 310.104(E) of the 2011 NEC.
Personnel Protection of Impedance Heating Systems
The requirements of Art. 426 apply to electrically energized heating systems such as fixed outdoor electric deicing and snow-melting equipment.
Inspection of Manufactured Wiring Assembly
The requirements in Art. 602 apply to field-installed wiring using off-site manufactured subassemblies for branch, remote-control, signaling and communication circuits in accessible areas.
Code Q&A: Connection of Appliances  1
Q. What is the general rule that limits the use of flexible cords for the connection of appliances?
Allowable Conductor Ampacity for Generator
Article 445 contains installation and other requirements for generators.
One Permitted Use of Nonmetallic Wireway
Article 378 covers the use, installation, and construction specifications for nonmetallic wireways and associated fittings.
Kitchen Equipment Load Calculations
Section 220.56 of the NEC addresses kitchen equipment installed in locations other than dwelling units.
Approved Uses of Flat Cable Assemblies
Article 322 covers the use, installation, and construction specifications for flat cable assemblies.
Electrical Testing Feed
Join the Discussion on EC&M Talk

EC&M Webinars
Sep 10, 2015

ON DEMAND: An Effective Electrical Safety Program that Delivers

This hour-long webinar will cover the wording in various IEEE recommended practices, NFPA 70E and ANSI Z10 with an emphasis on what it means in terms of designing, implementing and managing an Effective Electrical Safety Program....More
Jul 21, 2015

ON DEMAND: Mitigation Methods for Arc Flash Hazards - Enhancing Personal Safety

The energy released during an arc flash event can result in severe damage to personnel, equipment, and property. While there are solutions which seek to improve the protection for each, this program will focus on personnel....More
EC&M Learning Center

Connect With Us

Sponsored Introduction Continue on to (or wait seconds) ×