Mike Holt

Mike
Holt
Articles
Grounding & Bonding Definitions
Why is grounding so difficult to understand? One reason is because many do not understand the definition of many important terms
Code Q&A
Q. What type of fitting can I use to terminate ground wires in a metal box?
Legally Required and Optional Standby Systems 1
Emergency power systems (Art. 700) are at the top of the hierarchy of backup power systems. Legally required standby systems, which fall under Art. 701,
Stumped by the Code?
Q. Can 277V circuit conductors be placed within the same raceway with 120V circuit conductors?
Code Q&A
Q. Is liquidtight flexible metal conduit (LFMC) permitted under the raised floor of a computer room? If yes, must it be secured?
Code Q&A
Q. Can Table 310.15(B)(6) be used to size service conductors for a duplex?
Stumped by the Code? 1
Q. Is GFCI protection required for a single-phase, 208V, 30A coffee maker receptacle in a commercial kitchen?
Code Q&A
Q. When determining the placement for receptacles in a dwelling, is the wall space behind a door required to be considered?
Code Q&A
Q. Am I required to install the secondary circuit conductors of a low-voltage lighting system (less than 30V) in a raceway or cable like power conductors?
Article 700: Emergency Systems 1
Essentially, emergency systems are lifelines for people, and Art. 700 is all about keeping those lifelines from breaking. The Article's main goal is to
Code Q&A
Q. Does the NEC specifically state that a generator must be grounded to the earth if its wiring is connected to the premises via a transfer switch that does not open the neutral?
Code Q&A
Q. Can the service disconnect be located within 5 feet of a pool or hot tub?
Power to the Pump 3
One of the principal NEC requirements for circuit protection is that you shut down the equipment rather than let supply conductors melt from overload.
Stumped by the Code? 1
Q. I have six 18-foot metal poles to install in a parking area. Is a ground rod required at each pole? If not, then why do some people insist that they are required?
Code Q&A 1
Q. Can an air duct be installed directly above an electrical panel?

EC&M Learning Center

 

Newsletter Signup

Connect With Us

Sponsored Introduction Continue on to (or wait seconds) ×