John A. DeDad

John A.
The Basics of Autotransformers 5
An autotransformer is a transformer having part of its winding included in both the input and output circuit.
Testing Contact Quality on Live Motor Starters
This unique millivolt testing technique provides a basic check in troubleshooting motor breakdown situations.As a maintenance electrician, I'm sure you've
Get Real About Project Scheduling
Not only are realistic project schedules useful to you during the preconstruction stage, they're also vital to successfully coordinating the day-to-day
The basics of insulation resistance
One of the most fundamental of electrical installation and maintenance tasks is taking insulation resistance (JR) readings. This is done to verify the
Insulation resistance testing: How and why?
This basic electrical maintenance and troubleshooting test can help you diagnose potential insulation problems and reasonably predict when they will occur.How
The Basics of Insulation Resistance Testing 9
How significant is insulation resistance testing? Since 80% of electrical maintenance and testing involves evaluating insulation integrity, the answer is "very important."
Don't Take Chances with Your Life
Proper use of safety equipment on energized and de-energized circuits just might save your life.
Reality of Nostalgia 1
Recently, I was going through my electrical belongings and ran across some old “friends.” They brought back many memories of when I began working in the
Do Today's Electrical Measurements Leave You Dazed and Confused?
Modern test and measurement instruments go from simple DMMs to handheld oscilloscopes to very sophisticated spectrum and harmonic analyzers.
The Pros and Cons of Proof-Testing
The secret to not damaging old, in-service cable is to apply the maximum test voltage in small increments and closely monitor the behavior of leakage current.
Basic short-circuit current calculation 3
A basic electrical theorem says the amount of current that will flow through a short circuit depends on two variable values: The system voltage and the
The basics of transformers, part 2. 2
Copper losses in both primary and secondary windings, and core losses are converted into heat in a transformer. These losses are all measured in watts.
Using Your DMM and Scope Wisely
Here's a primer on symbology, terminology, connections, and operation for modern digital multimeters and oscilloscopes.
The basics of transformers - Part 1 1
A transformer is an energy coupling device that takes electrical energy at one voltage (from its source) and transforms it to another voltage. The new
Using single-phase transformers to create 3-phase systems.
Many older industrial facilities use single-phase, oil-filled transformers made for pole-mounting but installed at ground level to create 3-phase power
Electrical Testing Feed
Join the Discussion on EC&M Talk

EC&M Webinars
Jul 28, 2016

Next Generation Lighting- The Emergence of POE for Lighting

Historically, lighting controls have always had a singular responsibility: Manage the light. Until now....More
EC&M Learning Center

Connect With Us

Sponsored Introduction Continue on to (or wait seconds) ×